LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Servicing - A/T (VT25-E)) >> Removal & Installation >> Control Cable >> Installation

Control Cable: Installation

WARNING: This page is about a different car, the 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Route control cable through cable bracket. Secure cable to bracket with control cable retainer clip. An audible snap will be heard when properly installed. With transaxle range switch lever located in Neutral, snap cable end fitting onto ball stud of lever. An audible snap will be heard when properly installed.
  2. Position vehicle on hoist and raise vehicle. Route cable along steering gear assembly into clip and up into dash panel. Lower vehicle. Secure control cable grommet by pressing cable into pass-through hole in dash panel. See Figure . Make sure control assembly is in Neutral position.
  3. Connect control cable to control assembly. Secure with control cable retainer clip. Install control cable onto control assembly lever. See Figure . Adjust control cable assembly. See CONTROL CABLE  under ADJUSTMENTS. Install console. See CONSOLE  .
  4. Position battery tray bracket and tighten screws to specification. See Figure . See TORQUE SPECIFICATIONS  . Install battery cooling box. See BATTERY COOLING BOX  .
  5. Insert battery and tighten battery hold-down screw to specification. See Figure . Connect positive battery cable to battery and tighten to specification. Connect negative battery cable to battery and tighten to specification. Install battery cooling box cover and tighten screws to specification. See TORQUE SPECIFICATIONS  .
scientia non olet · About LEMON Manuals