LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Servicing - A/T (VT25-E)) >> Adjustments >> Transaxle Range Switch

Transaxle Range Switch

WARNING: This page is about a different car, the 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Shift transaxle into Neutral position. Using Fascia Retainer Remover (J36346), remove control cable assembly from transaxle range switch lever.
  2. Remove transaxle range switch lever nut and lever. Loosen transaxle range switch bolts. Insert Transaxle Range Switch Tool (J44810) as shown and rotate switch until tool drops into position. See Fig 1 . Transaxle range switch tool is aligned when pin on tool drops into hole on transaxle range switch. Tighten transaxle range switch bolts to specification. Remove alignment tool. Install transaxle range switch lever and nut, then tighten to specification. See TORQUE SPECIFICATIONS  .
  3. Install control cable assembly to transaxle range switch lever. After adjusting switch, verify engine starts only in Park or Neutral. If engine starts in any other position, readjust switch.
Fig 1: Installing Transaxle Range Switch Tool
G00078044Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals