LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 559 (Starting System) >> Removal & Installation >> Starter Motor >> Removal (Pickup w/6.6L Engine)

Removal (Pickup w/6.6L Engine)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, and 2003 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Raise and suitably support the vehicle.
  3. If equipped with 4-wheel drive (4WD), remove the right front tire and wheel.
  4. If equipped with 4WD, remove the right fender wheelhouse inner panel.
  5. Remove the battery positive cable from the starter motor.
  6. Remove the solenoid wires.
  7. Remove the starter motor bolts.
  8. Remove the starter motor.