LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 559 (Starting System) >> Removal & Installation >> Starter Motor >> Installation (Sport Utility w/4.8L, 5.3L, 6.0L & 8.1L Engines)

Installation (Sport Utility w/4.8L, 5.3L, 6.0L & 8.1L Engines)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, and 2003 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. If necessary, install the starter heat shield.
  2. If necessary, snap the transmission cover to the starter.
  3. Install the positive cable to the starter.
  4. Install and tighten the positive battery cable nut to specification. See TORQUE SPECIFICATIONS .
  5. Install the starter lead to the starter. See Figure.
  6. Install and tighten the starter lead nut to specification. See TORQUE SPECIFICATIONS .
  7. Position the starter into place.
  8. Install and tighten the starter bolts to specification. See TORQUE SPECIFICATIONS .
  9. On 4.8L, 5.3L and 6.0L engines, connect the oil level sensor electrical connector.
  10. If equipped with 4WD, position the front axle mounting bracket bolt until the bolt is fully seated. See Figure.
  11. If equipped with 4WD, install the front axle mounting bracket nuts. Tighten the nuts to specification. See TORQUE SPECIFICATIONS .
  12. On 4.8L, 5.3L and 6.0L engines, install the transmission cover bolt. See Figure. Tighten the bolt to specification. See TORQUE SPECIFICATIONS .
  13. Lower the vehicle.
  14. Connect the negative battery cable. Tighten negative battery cable bolt to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals