LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 559 (Starting System) >> Removal & Installation >> Starter Motor >> Installation (Pickup w/6.6L Engine)

Installation (Pickup w/6.6L Engine)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, and 2003 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the starter motor to the engine rear cover.
  2. Install and tighten the starter motor bolts to specification. See TORQUE SPECIFICATIONS .
  3. Install the solenoid wires.
  4. Install and tighten the starter solenoid nut to specification. See TORQUE SPECIFICATIONS .
  5. Install the battery positive cable to the solenoid stud.
  6. Install and tighten the starter lead nut to specification. See TORQUE SPECIFICATIONS .
  7. If equipped with 4WD, install the right fender wheelhouse inner panel.
  8. If equipped with 4WD, install the right front tire and wheel. Tighten wheel lug nuts to specification. See TORQUE SPECIFICATIONS .
  9. Lower the vehicle.
  10. Connect the negative battery cable. Tighten negative battery cable bolt to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals