LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 553 (Fwd Axle Shafts) >> Removal & Installation >> Intermediate Shaft >> Removal >> Intermediate Shaft Removal Note

Intermediate Shaft Removal Note

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the right side axle shaft from the intermediate shaft by tapping the transaxle side outer ring with a brass bar and hammer. See Figure .
  2. Disconnect the intermediate shaft bracket from cylinder block and remove the intermediate shaft.
    CAUTION: The sharp edges of the intermediate shaft can slice or puncture the oil seal. Be careful when removing the intermediate shaft from the transaxle.
  3. Install the Differential Side Gear Holder (49-G030-455) into the transaxle after the intermediate shaft is removed. See Figure .
scientia non olet · About LEMON Manuals