LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 553 (Fwd Axle Shafts) >> Overhaul >> Intermediate Shaft >> Disassembly >> Bearing Disassembly Note

Bearing Disassembly Note

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the bearing and the dust seals (both right and left side) using the Oil Seal Installer (49-B014-001) and the Support Block (49-H034-201). See Fig 1 .
  2. Remove the bearing from the intermediate shaft using the Bearing Remover (49-H027-002) and a press. See Fig 2 .
Fig 1: Disassembling Bearing
G00356662Courtesy of MAZDA MOTORS CORP.
Fig 2: Removing Bearing
G00318603Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals