LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 552 (Electric Cooling Fan) >> Removal & Installation >> Fan Shroud >> Removal

Fan Shroud: Removal

WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo and 2002 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable with the following procedures:
    1. Record all of the vehicle preset radio stations.
    2. Turn off all the lamps and the accessories.
    3. Make sure the ignition switch is in the OFF position.
    4. Disconnect the battery negative cable from the battery. See Fig 1 .
    Fig 1: Disconnecting Negative Battery Cable
    G00357870Courtesy of GENERAL MOTORS CORP.
  2. Partially drain the cooling system with the following procedures:
    1. Park the vehicle on a level surface.
    2. Remove the coolant pressure cap.
    3. Raise and support the vehicle.
    4. Place a drain pan under the drain cock.
    5. Open the radiator drain cock.
    6. Drain the cooling system.
  3. Raise and support the vehicle.
  4. Remove the transmission oil cooler lines from the retainers at the bottom of the cooling fan shroud.
  5. Lower the vehicle.
  6. Remove the right and the left engine mount struts. See Fig 2 , Fig 3 , Fig 4 , or Fig 5 .
    Fig 2: Removing Right Engine Mount Strut (3.4L Engine)
    G00357871Courtesy of GENERAL MOTORS CORP.
    Fig 3: Removing Left Engine Mount Strut (3.4L Engine)
    G00357872Courtesy of GENERAL MOTORS CORP.
    Fig 4: Removing Right Engine Mount Strut (3.8L Engine)
    G00357873Courtesy of GENERAL MOTORS CORP.
    Fig 5: Removing Left Engine Mount Strut (3.8L Engine)
    G00357874Courtesy of GENERAL MOTORS CORP.
  7. Remove the left front fender upper diagonal brace with the following procedures:
    1. Remove the electrical harness push-in connector from the brace.
    2. Remove the bolt from the front end sheet metal diagonal brace at the inner fender. See Fig 6 .
    3. Remove the bolts from the front end sheet metal diagonal brace at the radiator support.
    4. Remove the front end sheet metal diagonal brace.
    Fig 6: Removing Fender Upper Diagonal Brace
    G00357875Courtesy of GENERAL MOTORS CORP.
  8. Remove the radiator inlet hose from the radiator.
    9. NOTE: Do not disconnect PCM connectors when removing harness.
    Fig 7: Removing Air Cleaner Housing Cover
    G00357876Courtesy of GENERAL MOTORS CORP.
    Fig 8: Removing Air Cleaner Housing
    G00357877Courtesy of GENERAL MOTORS CORP.
  9. Remove the air cleaner assembly. See Fig 7 and Fig 8 .
  10. Remove the PCM harness from the fan shroud clip.
  11. If equipped remove the cooling fan heat shields.
  12. Disconnect the cooling fan shroud electrical connectors.
  13. Remove the cooling fan shroud bolts. See Fig 9 .
  14. Disengage the cooling fan shroud clip from the top of the radiator.
  15. Remove the radiator upper support brackets that connect to the fan shroud.
  16. Remove the cooling fan shroud.
Fig 9: Removing Cooling Fan Shroud
G00357878Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals