Vacuum Brake Booster: Removal
WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the air cleaner assembly.
- Disconnect and position aside the underhood electrical center from the bracket. Remove the underhood electrical center bracket.
- Remove the master cylinder from the hydraulic brake booster. See MASTER CYLINDER . Careful not lose or dislodge the insulator between the booster and the front of the dash.
- Disconnect the vacuum hose and the vacuum brake booster check valve from the booster as an assembly.
- Remove the left Closeout/Insulator Panel. Remove the booster retaining nuts.
- Disconnect the booster pushrod from the brake pedal. Tilt the vacuum brake booster slightly in order to work the booster pushrod off the pedal clevis pin. Do not apply excessive side pressure on the pushrod. Remove the booster from the vehicle.