LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Vacuum Brake Booster >> Installation

Vacuum Brake Booster: Installation

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the booster to the vehicle. Install the booster pushrod to the brake pedal. Tilt the vacuum brake booster slightly in order to work the booster pushrod onto the pedal clevis pin. Do not apply excessive side pressure on the pushrod. Align the pushrod with the pedal and assemble.
  2. Install the booster retaining nuts. Tighten the booster to brake pedal retaining nuts to specification. See TORQUE SPECIFICATIONS 
  3. Install the left Closeout Insulator Panel. Connect the vacuum hose and the vacuum brake booster check valve to the booster as an assembly.
  4. Install the master cylinder to the booster. Install the master cylinder. See MASTER CYLINDER  .
  5. Install the underhood electrical center bracket. Position back and connect the underhood electrical center. Install the cleaner assembly.
scientia non olet · About LEMON Manuals