LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Disc Brakes & Drum Brakes) >> Overhaul >> Front Brake Caliper >> Reassembly

Front Brake Caliper: Reassembly

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the new piston seal with Delco Supreme 11(R) GM P/N 12377967, or equivalent DOT-3 brake fluid from a clean, sealed brake fluid container. Install the lubricated, new piston seal into the caliper bore.
  2. Install the lubricated, new piston seal into the caliper bore. Install the caliper piston into the caliper bore. Install the new caliper dust boot seal. Install the bleeder valve and cap to the caliper and tighten the valve securely.
  3. Install the brake caliper to the vehicle. See FRONT BRAKE CALIPER  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals