LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 549 (Electric Cooling Fans) >> Removal & Installation >> Cooling Fan & Shroud >> Installation

Cooling Fan & Shroud: Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fan and the shroud onto the lip of the radiator bottom.
  2. Install the 2 bolts into the upper fan shroud and tighten. See TORQUE SPECIFICATIONS  .
  3. Connect the electrical connector.
  4. Clip the fan shroud to the radiator at the side panels.
  5. Using the Fan Clutch Remover & Installer, secure the water pump pulley, install the fan nut to the water pump shaft in a clockwise rotation. See TORQUE SPECIFICATIONS  .
  6. Install the transmission cooler lines to the engine and clip into the fan shroud.
  7. Install the hood latch support.
  8. Install the upper inlet radiator hose to the radiator.
  9. Reposition the upper inlet radiator hose clamp using Hose Clamp Pliers.
  10. Fill the cooling system.
scientia non olet · About LEMON Manuals