LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 543 (Disc Brakes) >> Removal & Installation >> Rear Brake Rotor >> Installation

Rear Brake Rotor: Installation

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake rotor to the hub/axle flange. Use the matchmark made prior to removal for proper orientation to the flange.
  2. If the brake rotor was removed and installed as part of a brake system repair, measure the assembled lateral runout (LRO) of the brake rotor to ensure optimum performance of the disc brakes. See BRAKE ROTOR ASSEMBLED LATERAL RUNOUT (LRO) MEASUREMENT  under ADJUSTMENTS & INSPECTIONS.
  3. If the brake rotor assembled LRO measurement exceeds the specification, bring the LRO to within specifications. See BRAKE ROTOR ASSEMBLED LATERAL RUNOUT (LRO) CORRECTION  under ADJUSTMENTS & INSPECTIONS.
  4. Install the caliper bracket. See REAR BRAKE CALIPER BRACKET  .
  5. Install the tire and the wheel. Tighten wheel lug nuts to specification. See TORQUE SPECIFICATIONS  .
  6. Lower the vehicle.
  7. If the brake rotor was refinished or replaced, or if new brake pads were installed, burnish the pads and rotors. See BURNISHING PADS & ROTORS  under SERVICING.
scientia non olet · About LEMON Manuals