LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 543 (Disc Brakes) >> Removal & Installation >> Park Brake Cable >> Removal (Front Cable)

Removal (Front Cable)

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left side instrument panel insulator.
  2. Use the door trim pad remover to remove the left front carpet retainer. Use the door trim pad remover to remove the left front pillar, lower trim panel. Remove the front and rear door weatherstrips from the pinchweld flange as required. Remove the lower trim panel from the center pillar using door trim pad remover. Remove the seat belt from the slot in the lower trim panel. Remove the lower trim panel from the vehicle.
  3. Fold back the carpeting in order to gain access to the park brake cable.
  4. Remove the park brake cable from the cable guides.
  5. Raise and support the vehicle.
  6. Remove the brake cable at the equalizer.
  7. Lower the vehicle.
  8. Remove the cable button end from the park brake lever clevis. See Fig 1 .
  9. Remove the front cable from the vehicle.
Fig 1: Removing Front Brake Cable
G00310744Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals