LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 543 (Disc Brakes) >> Removal & Installation >> Master Cylinder >> Installation

Master Cylinder: Installation

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Bench bleed the master cylinder. See MASTER CYLINDER BENCH BLEEDING  under BLEEDING BRAKE SYSTEM.
  2. Install the master cylinder to the power brake booster.
  3. Install the master cylinder mounting nuts. Tighten the master cylinder mounting nuts to specification. See TORQUE SPECIFICATIONS  .
  4. Remove the plugs from the brake pipes.
  5. Connect the brake pipes to the master cylinder. Tighten the brake pipe fittings at the master cylinder to specification. See TORQUE SPECIFICATIONS  .
  6. Connect the electrical connector to the brake fluid level sensor.
  7. Bleed the brake system. See BLEEDING BRAKE SYSTEM  .
scientia non olet · About LEMON Manuals