LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 543 (Disc Brakes) >> Removal & Installation >> Brake Pedal Assembly >> Installation

Brake Pedal Assembly: Installation

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake pedal and bushings.
  2. Install the brake pedal nut and bolt. Tighten the brake pedal nut and bolt to specification. See TORQUE SPECIFICATIONS  .
  3. Install the brake pedal washer and pushrod to the brake pedal.
  4. Install the brake pedal pushrod retaining clip to the brake pedal.
  5. Secure the wiring harness clips to the bracket.
  6. If equipped, install the cruise control release switch.
  7. Install the stoplight switch. See STOPLIGHT SWITCH  .
  8. Insert the top of the BCM up into the mounting bracket, then engage the bottom of the BCM into the mounting bracket slot.
  9. Install the left instrument panel insulator.
scientia non olet · About LEMON Manuals