LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Power Rack & Pinion Steering System) >> Repair Instructions >> Rack and Pinion Outer Tie Rod End Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Outer/Inner Tie Rod & Jam Nut
    GM687434Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the inner tie rod (3) threads with a suitable chassis lubricant before installing the outer tie rod (2).
  2. Install the new jam nut (1) to the outer tie rod (2).
  3. Install the outer tie rod (2) to the inner tie rod (3).
    4. Fig 2: Removing/Installing Tie Rod
    GM687435Courtesy of GENERAL MOTORS CORP.
  4. Install the outer tie rod to the steering knuckle.
    5. NOTE: Refer to FASTENER NOTICE .
  5. Install the new outer tie rod retaining nut.

    Tighten:  Tighten the outer tie rod retaining nut to 60 N.m (44 lb ft).

  6. Install the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
  7. Lower the vehicle.
  8. Adjust the front toe. Refer to FRONT TOE ADJUSTMENT .
scientia non olet · About LEMON Manuals