LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 535 (Charging System) >> Removal & Installation >> Generator >> Removal (3.8L)

Removal (3.8L)

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Delphi CS130D (K68) 105-amp generator is serviced as a complete unit only.
  1. Disconnect negative battery cable.
  2. Remove drive belt from generator.
  3. Remove generator rear brace.
  4. Remove bolts (1 & 3) and stud (2) from generator. See Fig 1 .
  5. Disconnect electrical connector from generator.
  6. Position aside protective boot from generator output BAT terminal for access.
  7. Remove generator output BAT terminal nut and remove positive battery cable from generator.
  8. Remove generator.
Fig 1: Removing Generator (3.8L)
G00060591Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals