LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 534 (Charging System) >> Removal & Installation >> Generator >> Removal (3.1L)

Removal (3.1L)

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Delphi CS130D (K68) 105-amp generator is serviced as a complete unit only.
  1. Disconnect negative battery cable.
  2. Remove drive belt from generator.
  3. Place coolant recovery reservoir aside for access.
  4. Remove bolts (1, 2 & 3) from generator. See Fig 1 .
  5. Disconnect electrical connector from generator.
  6. Remove protective boot from generator output BAT terminal.
  7. Remove generator output BAT terminal nut and remove positive battery lead from generator.
  8. Remove generator.
Fig 1: Removing Generator (3.1L)
G00060590Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals