LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Park Brake Hardware >> Removal

Park Brake Hardware: Removal

WARNING: This page is about a different car, the 2003 Buick Regal, 2003 Buick Century, 2002 Buick Regal, and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise support the vehicle. Remove the tire and wheel assembly. Remove the brake drum. See BRAKE DRUM  under REMOVAL & INSTALLATION.
  2. Position the hook end of the Brake Shoe Spanner and Spring Remover (J-38400), (1) under the universal spring and lightly pull the universal spring end out of the shoe web hole. See Fig 1 . Hold the universal spring while removing the brake shoe.
  3. Disconnect the park brake lever from the brake shoe by removing the retaining clip. Disconnect the park brake lever from the park brake cable.
Fig 1: Removing Brake Shoe
G00284626Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals