Master Cylinder: Removal

WARNING: This page is about a different car, the 2003 Buick Regal, 2003 Buick Century, 2002 Buick Regal, and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the electrical connector from the brake fluid level sensor. Disconnect the brake pipes from the master cylinder.

NOTE: Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.

Plug the open brake pipe ends. Remove master cylinder mounting nuts. Remove the master cylinder from the vehicle. Drain the master cylinder reservoir of all brake fluid.