LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Brake Pedal Assembly >> Removal

Brake Pedal Assembly: Removal

WARNING: This page is about a different car, the 2003 Buick Regal, 2003 Buick Century, 2002 Buick Regal, and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left instrument panel insulator.
  2. Remove the Body Control Module (BCM) from the bracket and position aside.
  3. Remove the stoplight switch. See STOPLIGHT SWITCH  .
  4. Remove the cruise control release switch, if equipped.
  5. Remove the wiring harness clips from the bracket.
  6. Remove the brake pedal pushrod retaining clip from the brake pedal. See Fig 1 .
  7. Remove the brake pedal pushrod and washer from the brake pedal.
  8. Remove the brake pedal nut and bolt. See Fig 2 . Remove the brake pedal and bushings.
Fig 1: Removing & Installing Brake Pedal Pushrod Retaining Clip
G00284629Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Brake Pedal Nut and Bolt
G00284630Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals