LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Brake Hose (Rear Drum) >> Installation

Brake Hose (Rear Drum): Installation

WARNING: This page is about a different car, the 2003 Buick Regal, 2003 Buick Century, 2002 Buick Regal, and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake hose (1) into the hose mounting brackets (3). There should not be any kinks in the hose. Align the hose fitting with the notch in the bracket. Use the hose paint stripe as a visual aid. Install the retainer clips (4) onto the hose fittings at the brackets. Use a backup wrench (2) on the hose fitting in order to connect the brake pipe to the brake hose (1). DO NOT bend the bracket or the pipe. See Figure .
  2. Tighten the brake pipe fittings. Tighten to specifications. See TORQUE SPECIFICATIONS  .
  3. Install the rear tire and wheel. Lower the vehicle. Ensure that the hose does not make contact with any part of the suspension. If the hose makes contact, remove the hose and correct the condition. Bleed the hydraulic brake system. See BLEEDING BRAKE SYSTEM  .
scientia non olet · About LEMON Manuals