LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Disc Brakes & Drum Brakes) >> Overhaul >> Rear Caliper >> Assembly

Rear Caliper: Assembly

WARNING: This page is about a different car, the 2003 Buick Regal, 2003 Buick Century, 2002 Buick Regal, and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the new piston seal with Delco Supreme 11(R), GM P/N 12377967, or equivalent DOT-3 brake fluid from a clean, sealed brake fluid container.
  2. Install the lubricated, new piston seal into the caliper bore.
  3. Apply a thin coat of Delco Supreme 11(R), GM P/N 12377967, or equivalent DOT-3 brake fluid from a clean, sealed brake fluid container onto the outer surface area of the caliper piston.
  4. Install the bottom half of the caliper piston into the caliper bore.
  5. Install the new piston dust boot seal over the caliper piston.
  6. Compress the caliper piston to the bottom of the caliper bore.
  7. Fully seat the piston dust boot seal into caliper counterbore.
  8. Install the retaining ring that secures the dust boot to the caliper housing.
  9. Install the bleeder valve and cap to the caliper and tighten the valve securely.
  10. Install the rear brake caliper to the vehicle. See CALIPER REPLACEMENT (REAR)  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals