LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 527 (Axle Shafts - Rear) >> Overhaul >> Axle Shaft Inner Joint & Seal >> Disassembly

Axle Shaft Inner Joint & Seal: Disassembly

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Required Tools: Drive Shaft Seal Clamp Pliers (J-42572).
  1. Remove the large boot retaining clamp from the CV joint seal. Use a side cutter or other suitable tool and discard the clamp. Remove the small boot retaining clamp from the joint seal. Use a side cutter or other suitable tool and discard clamp. Place reference marks on the inboard and outboard joint shafts. Pull out the inboard joint.
  2. Place reference marks on the outboard joint shaft, the inner race and cage. Remove the 6 balls from the outboard joint shaft. Wipe the grease from the face of the joint inner race, cage, balls, etc. Slide the cage toward the outboard joint.
  3. Remove the snap ring. Using a brass bar and hammer, remove the inner race from the shaft. Clean the inner race, the outer race, the cage, the balls, the axle shaft exposed end thoroughly with clean solvent. Thoroughly air dry all the parts.
scientia non olet · About LEMON Manuals