LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 523 (Charging System) >> Diagnostic Tests >> DTC P0620: Generator Turn On Signal Circuit Low >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. If engine electrical diagnostic system check was performed, go to next step. If engine electrical diagnostic system check was not performed, go to ENGINE ELECTRICAL DIAGNOSTIC SYSTEM CHECK  under ON-VEHICLE TESTING.
  2. Connect scan tool to Data Link Connector (DLC). Turn ignition switch to RUN position. Using scan tool, observe specific DTC information for DTC P0620 from engine controls. If scan tool indicates DTC P0620 failed this ignition, go to next step. If scan tool indicates DTC P0620 passed this ignition, problem may be intermittent. Check wiring and connections, and see PRELIMINARY INSPECTION  under TROUBLE SHOOTING.
  3. Test generator turn-on signal circuit for a short to ground. See WIRING DIAGRAMS  . If no problem exists, go to next step. If problem exists, repair circuit as necessary and then go to step  6 .
  4. Inspect PCM harness connector for poor connections. If no problem exists, go to next step. If problem exists, repair as necessary and then go to step  6 .
  5. Replace PCM. See REMOVAL & INSTALLATION article in ENGINE PERFORMANCE. Program PCM. After repair, go to next step.
  6. Review and record scan tool fail records data. Using scan tool, clear DTCs. Start engine. Using scan tool, observe specific DTC information for DTC P0620 until test runs. If scan tool indicates DTC P0620 passed this ignition, system is okay. If scan tool indicates DTC P0620 failed this ignition, go to step  2 .
scientia non olet · About LEMON Manuals