LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Automatic Transaxle Diagnosis - 4T65-E) >> Self-Diagnostic System >> Diagnostic System Check >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2002 Buick Regal, 2002 Buick Century, 2001 Buick Regal, and 2001 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Check for applicable service bulletins before proceeding with this diagnostic procedure. Perform this diagnostic procedure only if there is a driveability complaint or if you have been directed to this diagnostic procedure from another section in the service information.
    NOTE: Do not turn the ignition off when performing this diagnostic procedure. Do not clear the DTCs unless instructed by this diagnostic procedure.
  1. Turn ignition on, engine off. Does the scan tool turn on? If so, go to next step. If not, diagnose scan tool concern. See appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT.
  2. Is the MIL on? If so, go to next step. If not, diagnose MIL concern. See appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE.
  3. Attempt to establish communication with the PCM. Does the scan tool communicate with the PCM? If so, go to next step. If not, diagnose scan tool concern. See appropriate BODY CONTROL MODULES article in ACCESSORIES & EQUIPMENT.
    4. NOTE: DTCs, engine performance, and transaxle default actions can greatly affect the transaxle performance. Ensure that these items are not the cause of a transaxle concern.
  4. Use the scan tool CAPTURE INFO function to save or capture (store information) any DTC information. Are there any DTCs present? If so, see DIAGNOSTIC TROUBLE CODE DEFINITIONS  . If not, see SYMPTOM DIAGNOSIS  under TROUBLE SHOOTING.
scientia non olet · About LEMON Manuals