LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Automatic Transaxle Diagnosis - 4T65-E) >> Removal & Installation >> Pressure Control Solenoid Valve >> Installation

Pressure Control Solenoid Valve: Installation

WARNING: This page is about a different car, the 2002 Buick Regal, 2002 Buick Century, 2001 Buick Regal, and 2001 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install new "O" ring seals (307, 316) onto the pressure control (PC) solenoid valve (322), if they had been removed. See Fig 1 .
  2. Install the pressure control solenoid (322).
  3. Hold the PC solenoid valve (322) in the control valve body (301). Install the pressure control solenoid valve retainer (314E) into the control valve body (301).
  4. Connect the transaxle wiring harness.
  5. Install the case side cover. See appropriate AUTOMATIC article in TRANSMISSION SERVICING.
Fig 1: Exploded View Of Pressure Control Solenoid Valve Components
G00073401Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals