LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Automatic Transaxle Diagnosis - 4T65-E) >> Performance Tests >> Road Test >> Manual Downshifts

Manual Downshifts

WARNING: This page is about a different car, the 2002 Buick Regal, 2002 Buick Century, 2001 Buick Regal, and 2001 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

The shift solenoid valves do not control the 4-3 manual downshift. The 4-3 manual downshift is hydraulic. The 3-2 and 2-1 manual downshifts are electronic. The solenoid states will change during or shortly after a 4-3 downshift is selected.

  1. 4-3 Downshift

    Place the gear selector in the Overdrive position. Accelerate the vehicle to 40-55 MPH in 4th gear. Release the throttle while moving the gear selector to 3rd.
  2. Verify the TCC releases, the transaxle downshifts immediately to 3rd gear, and the engine slows the vehicle.

  1. 4-2 Downshift

    Place the gear selector in the Overdrive position. Accelerate the vehicle to 40-45 MPH. Release the throttle while moving the gear selector to 2nd.
  2. Verify the TCC releases, the transaxle downshifts immediately to 2nd gear, and the engine slows the vehicle.

  1. 4-1 Downshift

    Place the gear selector in the Overdrive position. Accelerate the vehicle to 40 MPH. Release the throttle while moving the gear selector to 1st.
  2. Verify the TCC releases, the transaxle downshifts immediately to 2nd gear, the engine slows the vehicle, and the transaxle downshifts to 1st gear at the calibrated speed, typically 30-40 MPH.
scientia non olet · About LEMON Manuals