LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 512 (Disc Brakes) >> Removal & Installation >> Rear Disc Brake Backing Plate >> Removal (1500 Series Utility Without 4-Wheel Steering)

Removal (1500 Series Utility Without 4-Wheel Steering)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, and 2003 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake.
  2. Raise and support the vehicle.
  3. Remove the tire and wheel assembly.
  4. Relieve the tension from the park brake cable by pulling down on the cable in front of the equalizer and removing the cable from the equalizer bar.
  5. Remove the park brake cable from the mounting bracket by depressing the locking tabs.
  6. Remove the rear park brake cable end from the park brake actuator lever.
  7. Remove the rotor. See BRAKE ROTOR .
  8. Remove the axle shaft. See AXLE SHAFTS under REMOVAL & INSTALLATION in the appropriate DIFFERENTIALS article in DRIVELINE/AXLES.
  9. Remove the park brake shoe. See PARK BRAKE SHOES .
  10. Remove the backing plate nuts.
  11. Remove the backing plate from axle housing flange.
scientia non olet · About LEMON Manuals