LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 512 (Disc Brakes) >> Removal & Installation >> Park Brake Pedal Assembly >> Removal

Park Brake Pedal Assembly: Removal

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, and 2003 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Raise and support the vehicle.
  3. Relieve the tension from the park brake cables from the equalizer by pulling down on the intermediate cable and release the rear cables from the equalizer bar. See Fig 1.
  4. Remove the safety stands.
  5. Lower the vehicle.
  6. Remove the left side hinge pillar panel.
  7. Disconnect the park brake warning lamp connection.
  8. Remove the MID-Bussed Electrical Center bracket.
  9. Disconnect the park brake release cable from the park brake lever. See Figure.
  10. Remove the park brake lever mounting nuts.
  11. Disconnect the front park brake cable from the park brake lever.
  12. Remove the park brake lever.
Fig 1: Relieving Tension From Cables
G00317483Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals