LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 512 (Disc Brakes) >> Removal & Installation >> Park Brake Cable >> Removal (Left Rear - Without 4-Wheel Steering)

Removal (Left Rear - Without 4-Wheel Steering)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, and 2003 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake.
  2. Raise and support the vehicle.
  3. Relieve the tension from the park brake cable by pulling down on the cable in front of the equalizer and removing the cable from the equalizer bar.
  4. Remove the cable from the mounting bracket by depressing the locking tabs. See Fig 1.
  5. Remove the cable at the shock absorber bracket by removing the bolt. See Fig 2.
  6. On all models except 1500 series utilities, remove the cable from the lever. See Figure.
  7. Remove the cable from the backing plate by depressing the locking tabs.
  8. Remove the cable.
  9. On 1500 series utilities, remove the cable from the lever. See Fig 3.
  10. Remove the cable from the backing plate by depressing the locking tabs.
  11. Remove the cable.
Fig 1: Removing Cable From Mounting Bracket
G00317487Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing Cable At Shock Absorber Bracket
G00317488Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing Cable From Lever
G00317489Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals