LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 512 (Disc Brakes) >> Removal & Installation >> Hydraulic Brake Booster Accumulator >> Installation

Hydraulic Brake Booster Accumulator: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, and 2003 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate all of the seals and the metal friction points with power steering fluid. See Figure.
  2. Install the accumulator and the "O" ring seal.
  3. Place the accumulator piston compressor over the end of the accumulator. See Figure.
  4. Install the nut on the stud.
  5. Depress the accumulator with a C-clamp.
  6. Install the accumulator retainer ring. See Figure.
  7. Release the C-clamp. See Figure.
  8. Remove the nut from the stud.
  9. Remove the accumulator piston compressor.
  10. Install the master cylinder to the hydraulic booster. See MASTER CYLINDER .
  11. Release the park brake and unblock the wheels.
scientia non olet · About LEMON Manuals