LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 512 (Disc Brakes) >> Removal & Installation >> Combination Valve >> Installation

Combination Valve: Installation

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, and 2003 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the combination valve to the vehicle.
  2. Install the front and the rear brake pipes to the combination valve.
  3. Tighten to specification. See TORQUE SPECIFICATIONS .
  4. Connect the combination valve electrical connector.
    5. NOTE: Verify that the combination valve metering rod is depressed during bleeding.
  5. Bleed the brake system. See BLEEDING BRAKE SYSTEM .
scientia non olet · About LEMON Manuals