Installation (Front)
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, and 2003 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
- Assemble the 2 NEW copper brake hose gaskets and the brake hose bolt to the brake hose. See Figure.
- Install the brake hose to caliper bolt and 2 NEW washers to the brake caliper. Tighten the bolt to specification. See TORQUE SPECIFICATIONS .NOTE: The brake hose must not be twisted. Make sure the brake hose is not in contact with any suspension component.
- With the weight of the vehicle on the suspension, install the brake hose into the bracket.
- Install the brake hose bolt and the bracket to the steering knuckle. See Figure. Tighten the bolt to specification. See TORQUE SPECIFICATIONS .
- Install the brake hose bolt and the bracket to the upper control arm. Tighten the bolt to specification. See TORQUE SPECIFICATIONS .
- Install the brake hose retaining clip.
- Remove the rubber cap or plug from the exposed brake pipe fitting end.
- Connect the brake pipe fitting nut to the brake hose. Use a backup wrench on the hose fitting. Do not bend the bracket or the pipe. Tighten the bolt to specification. See TORQUE SPECIFICATIONS .
- Bleed the hydraulic brake system. See BLEEDING BRAKE SYSTEM .
- Install the tire and wheel assembly. Tighten to specification. See TORQUE SPECIFICATIONS .
- Ensure that the hose does not make contact with any part of the suspension or the wheel. Check the hose in extreme right and left turn conditions. If the hose makes contact, remove the hose and correct the condition.
- Lower the vehicle.