LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 512 (Disc Brakes) >> Removal & Installation >> Brake Caliper Bracket >> Removal (Rear - Utility Without 4-Wheel Steering)

Removal (Rear - Utility Without 4-Wheel Steering)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, and 2003 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the tire and wheel assembly.
  3. Remove the brake caliper from the brake caliper mounting bracket and support the brake caliper with heavy mechanic's wire or equivalent. DO NOT disconnect the hydraulic brake hose from the brake caliper. See BRAKE CALIPER .
  4. Remove the brake pads from the brake caliper mounting bracket. See Figure.
  5. Remove the anti-rattle clips from the brake caliper bracket.
  6. Remove the brake caliper bracket mounting bolts. See Figure.
  7. Remove the brake caliper bracket.
  8. Remove any contaminants or foreign material from the inside ends of the brake caliper bracket.
  9. Clean the mounting surface and threads of the brake caliper bracket.
scientia non olet · About LEMON Manuals