LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 512 (Disc Brakes) >> Overhaul >> Brake Caliper >> Reassembly (Rear - 1500 Series)

Reassembly (Rear - 1500 Series)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, and 2003 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake caliper bleed screw. See Figure. Tighten the brake caliper bleed screw to specification. See TORQUE SPECIFICATIONS .
  2. Install the brake caliper bleed screw cap.
  3. Lubricate the NEW piston seal and the brake caliper bore seal groove with brake fluid.
  4. Install the NEW seal into the brake caliper bore seal groove.
  5. Ensure that the seal is not twisted.
  6. Lubricate the brake caliper bore and the piston with brake fluid.
  7. Install the boot and piston.
    1. Install the boot over the end of the piston so that the fold will face toward the brake caliper housing piston bore opening.
    2. Seat the boot into the brake caliper bore groove. Slide the piston into the brake caliper bore.
    3. Push down the piston to the bottom of the brake caliper bore.
    4. Ensure that the boot is properly seats into the piston groove and into the groove in the brake caliper bore.
  8. Install the brake caliper to the vehicle. See BRAKE CALIPER  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals