Inspection (Rear - Utility)
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2003 GMC Yukon XL, 2003 GMC Yukon, 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, and 2003 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the disc brake caliper from the caliper mounting bracket.
- Remove the disc brake pads from the caliper mounting bracket.
- Inspect the disc brake pad mounting hardware for the following:
- Missing mounting hardware
- Excessive corrosion
- Bent mounting tabs
- Looseness at the caliper mounting bracket
- Looseness at the disc brake pads
If any of the conditions listed are found, the disc brake pad mounting hardware requires replacement.
- Ensure the disc brake pads are held firmly in place on the caliper mounting bracket, yet slide easily on the mounting hardware without binding.
- Install the disc brake pads to the caliper mounting bracket.
- Install the disc brake caliper to the mounting bracket.