LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 511 (Disc Brakes (Cab & Chassis, & Hd)) >> Removal & Installation >> Rear Disc Brake Backing Plate >> Installation

Rear Disc Brake Backing Plate: Installation

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the backing plate.
  2. Install the backing plate bolts. Tighten the bolt to specification. See TORQUE SPECIFICATIONS  .
  3. Install the rear disc brake rotor. See BRAKE ROTOR  .
  4. Install the tire and the wheel assembly.
    NOTE: Pump the brake pedal until it is firm before moving the vehicle. Check the brake fluid level in the master cylinder after pumping the brakes.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals