LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 511 (Disc Brakes (Cab & Chassis, & Hd)) >> Removal & Installation >> Hydraulic Brake Booster Accumulator >> Installation

Hydraulic Brake Booster Accumulator: Installation

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate all seals and metal friction points with power steering fluid.
  2. Install the accumulator and "O" ring seal. See Figure .
  3. Place the accumulator piston compressor over the end of the accumulator. See Figure .
  4. Install the nut on the stud.
  5. Depress the accumulator with a C-clamp.
  6. Install the accumulator retainer ring. See Figure .
  7. Release the C-clamp. See Figure .
  8. Remove the nut from the stud.
  9. Remove the accumulator piston compressor.
  10. Install the master cylinder. See Figure . See MASTER CYLINDER  .
scientia non olet · About LEMON Manuals