LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 511 (Disc Brakes (Cab & Chassis, & Hd)) >> Removal & Installation >> Brake Rotor >> Removal (Rear)

Removal (Rear)

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle.
  2. Remove the tire and wheel assembly.
    CAUTION: Support the brake caliper with heavy mechanic's wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.
  3. Remove the caliper from the mounting bracket and support the caliper with heavy mechanic's wire or equivalent. Do not disconnect the hydraulic brake flexible hose from the caliper. See BRAKE CALIPER  .
  4. Remove the brake rotor and hub assembly. See HUB & ROTOR ASSEMBLY under REMOVAL & INSTALLATION in appropriate AXLE SHAFTS article in DRIVELINE/AXLES.
  5. Press the wheel studs out of the brake rotor and hub assembly. See Fig 1 .
  6. Remove the brake rotor from the hub.
Fig 1: Removing Rear Rotor From Hub
G00317532Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals