Removal (Front)
WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Support the brake caliper with heavy mechanic's wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.
NOTE:
Use the brake caliper mounting plate in order to mount all of the stationary brake components. An L or R following the part number cast on the back of the plates indicates left or right side mounting. Some plates may also have an L or R painted on the front.
- Remove the brake caliper from the mounting bracket and support the caliper with heavy mechanic's wire or equivalent. See Fig 1 . Do not disconnect the hydraulic brake flexible hose from the caliper. See BRAKE CALIPER .
- Remove the hub and brake rotor assembly. See HUB under REMOVAL & INSTALLATION in appropriate AXLE SHAFTS article in DRIVELINE/AXLES.
- Remove the spindle to mounting plate nuts.
- Remove the spindle/mounting plate cover.
- Remove the brake caliper mounting plate.
- Inspect the support rails for rust, corrosion, and wear.
- Clean the support rails with a wire brush.
- Inspect the brake caliper mounting plate for cracks or elongated bolt holes. Replace the mounting plate if necessary.