LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 511 (Disc Brakes (Cab & Chassis, & Hd)) >> Removal & Installation >> Brake Caliper Mounting Plate >> Installation (Rear)

Installation (Rear)

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the brake caliper mounting plate to the rear axle. See Figure .
  2. Install the splash shield.
    NOTE: Ensure that the threads are clean and greaseless before applying Threadlocker.
  3. Apply Threadlocker (GM P/N 12345493), or the equivalent, to the threads of each brake caliper mounting plate bolt.
  4. Install the brake caliper mounting plate bolts. Tighten the brake caliper mounting plate bolts to specification. See TORQUE SPECIFICATIONS  .
  5. Install the brake rotor. See BRAKE ROTOR  .
  6. Install the brake caliper. See BRAKE CALIPER  .
  7. Install the tire and the wheel assembly.
  8. Lower the vehicle.
  9. With the engine off, gradually apply the brake pedal approximately 2/3 of its travel distance.
  10. Slowly release the brake pedal.
  11. Wait 15 seconds, then repeat steps  9 and  10 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
scientia non olet · About LEMON Manuals