LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 511 (Disc Brakes (Cab & Chassis, & Hd)) >> Adjustments & Inspection >> Disc Brake Mounting & Hardware Inspection >> Inspection (Front)

Inspection (Front)

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the disc brake caliper from the caliper mounting plate.
  2. Remove the disc brake pads from the caliper.
  3. Inspect the disc brake pad mounting hardware for the following: See Figure .
    • Missing mounting hardware.
    • Excessive corrosion.
    • Bent mounting tabs.
    • Looseness at the caliper mounting bracket.
    • Looseness at the disc brake pads.
  4. If any of the conditions listed are found, the disc brake pad mounting hardware requires replacement.
  5. Ensure the disc brake pads are held firmly in place on the caliper mounting bracket.
  6. Install the disc brake pads to the caliper mounting bracket.
  7. Install the disc brake caliper to the mounting plate.
scientia non olet · About LEMON Manuals