LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 509 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Park Brake Lever Assembly >> Removal

Park Brake Lever Assembly: Removal

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear floor console. See REAR FLOOR CONSOLE  .
  2. Disconnect the park brake switch electrical connector. See Fig 1 .
  3. Remove the upper park brake front cable nut. Remove the lower park brake front cable nut.
  4. Remove the 2 bolts and the lever. Unfasten the tab in order to remove the park brake front cable from the lever.
  5. Remove the screw from the park brake switch. Remove the park brake switch.
Fig 1: Removing & Installing Park Brake Lever
G00305202Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals