LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 509 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Brake Shoes >> Removal

Brake Shoes: Removal

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Remove tire and wheel. Remove the brake drum. See BRAKE DRUM  .
  2. Remove the upper return spring. See Figure . Remove the lower return spring.
  3. Remove the hold-down spring cup, hold-down spring and pin from the front shoe.
  4. Remove the anchor spring. Remove the front shoe with the adjuster lever.
  5. Remove the adjuster lever and the adjuster spring from the front shoe.
  6. Remove the hold-down spring cup, hold-down spring and pin from the rear shoe.
  7. Disconnect the park brake cable from the park brake lever. Remove the rear shoe.
  8. Remove the following components:
    • The 2 C-shaped park brake lever washers.
    • The park brake lever.
    • The adjuster strut.
  9. Separate the adjuster strut components.
scientia non olet · About LEMON Manuals