LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 509 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Brake Pedal Assembly >> Removal

Brake Pedal Assembly: Removal

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Disconnect the stoplight switch connector.
  3. Remove the clip from the push rod clevis pin. See Figure .
  4. Remove the push rod clevis pin and the washer from the push rod clevis.
  5. Remove the push rod clevis from the brake pedal.
  6. Remove the 4 bracket nuts.
  7. Remove the shaft bolt and the nut.
  8. Remove the pedal from the bracket.
  9. Remove the bushings from the pedal. Remove the cover from the pedal.
scientia non olet · About LEMON Manuals