LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 509 (Disc Brakes & Drum Brakes) >> Overhaul >> Master Cylinder >> Reassembly

Master Cylinder: Reassembly

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Wash the new internal parts with clean brake fluid. Place the master cylinder in a vise.
  2. Install the following components into the master cylinder:
    • The secondary piston and spring.
    • The primary piston and spring.
    • The piston guide.
    • The O-ring.
    • The cylinder cup.
    • The plate.
    • The snap ring.
    • The O-ring.
    See Figure .
  3. Push the piston into the cylinder and install the gasket and the piston stopper bolt.
  4. Wash the grommets in brake fluid. Install the 2 grommets. Remove the master cylinder from the vise. Install the master cylinder to the vehicle.
scientia non olet · About LEMON Manuals