Brake Booster Piston Rod
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Place the Brake Booster Piston Rod Height Gage (J-39567) on the master cylinder.
- Push the Gage pin down until it touches the master cylinder piston.
- Remove the Gage from the master cylinder.
- Turn the Gage upside down.
- Set the Gage on the booster.
- The clearance between the booster piston rod and the Gage should be 0" (0 mm).
- If the measurement does not equal the specification, use the Brake Booster Piston Rod Adjuster (J-37767) in order to hold the booster piston rod.
- Turn the adjusting screw of the piston rod in order to adjust the clearance.