LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 508 (Disc Brakes) >> Removal & Installation >> Park Brake Cable >> Removal - Front

Removal - Front

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the park brake lever. See PARK BRAKE LEVER ASSEMBLY .
  2. Raise and support the vehicle.
  3. Remove the rear stabilizer shaft bracket bolts and nuts. Remove the rear stabilizer shaft brackets and insulators. Position the stabilizer shaft downwards. Remove the left side exhaust muffler bolts. Remove the exhaust muffler gasket. Slide the muffler blade out from the hanger. Remove right muffler.
  4. Disconnect the rear park brake cables from the equalizer.
  5. Disconnect the front park brake cable from the cable retainer.
  6. Remove the front park brake cable bracket from the tunnel.
  7. Lower the vehicle.
  8. Remove the front cable from the vehicle.
  9. Remove the pass-through grommet and front bracket from the cable.
scientia non olet · About LEMON Manuals